This article will guide you through the configuration of an ASUS Router or Modem/Router for your Superloop Internet Connection
- ASUS Routers will generally have the model number starting with the letters 'RT', whilst modem/routers will begin with the letters 'DSL' (i.e. RT-AC68U, DSL-AC55U)
- FttP/HFC/FttC connections will have an NBN Connection Box, so do not require a modem/router. Modem/routers are still compatible, but will require extra configuration steps
- This guide is a generic guide for ASUS devices, some settings may vary, depending on model
ASUS Routers for FttP/HFC/FttC
- Ensure the router is turned on and plugged in
- Get a device you can connect to the router with, either by Wi-Fi or ethernet
- Open a web browser on that device and enter 192.168.1.1
- Log in with the default admin password (should be listed on the router)
- Select WAN under Advanced Settings
- Change WAN Connection Type to Automatic IP
- Ensure WAN & NAT are both enabled
- Click Apply at the bottom of the page
- Your router should now be setup
ASUS Modem/Routers for FttP/HFC/FttC
- Ensure the modem/router is turned on and plugged in
- Get a device you can connect to the modem/router with, either by Wi-Fi or ethernet
- Open a web browser on that device and enter 192.168.1.1
- Log in with the default admin password (should be listed on the router)
- Select WAN under Advanced Settings
- Change Transfer Mode to ‘Ethernet WAN’
- Change WAN Connection Type to Automatic IP
- Ensure WAN & NAT are both enabled
- Click Apply at the bottom of the page
- Your modem/router should now be setup
ASUS Modem/Routers for FttN/FttB
- Ensure the modem/router is turned on and plugged in
- Get a device you can connect to the modem/router with, either by Wi-Fi or ethernet
- Open a web browser on that device and enter 192.168.1.1
- Log in with the default admin password (should be listed on the router)
- Select WAN under Advanced Settings
- Ensure Transfer Mode is set to VDSL WAN
- Change WAN Connection Type to Automatic IP
- Ensure WAN & NAT are both enabled
- Click Apply at the bottom of the page
- Your modem/router should now be setup